1.  Sand Testing

  • AFS Analysis
  • PermeabilityTesting
  • Compressive Strength Testing
  • Clay Content Test

2. Spectrometer

  • Model: Spectromaxx
  • Fe & Ni Base
  • Certified Reference Materials in:
    • Low Alloy Steel
    • Martensitic Steel
    • Austenitic Stainless Steel
    • Duplex Steel
    • Nickel Base Alloy

3. Chemical Analysis

  • All Type of Raw material Analysis by Wet Method

4. PMI Testing

  • Material testing

5. Mechanical Testing

  • UTM capacity of 200 KN
  • Electronic Extensometer for 0.2% proof stress.

6. Impact Testing

  • Capacity: 300 J max.
  • Testing Temp: From 20°C to -196°C

7. Hardness Testing

  • Rockwell Hardness Tester.
  • Poldy Hardness Tester.
  • Brinell Hardness Tester.

8. Micro Structure Examination

  • Ferrite Testing as per ASTM E 562 etc.
  • Micro Structure Examination as per ASTM A 923 etc.

9. Corrosion Test

  • Corrosion test according to ASTM A262 Practice A, B, C, E & F etc.
  • Pitting Corrosion Test as per ASTM G 48 Method A, E
  • Crevice Corrosion as per ASTM G48 Method B

10. Radiation Check Meter

  • Radioactive contamination in material

11. In-House Non Destructive Testing

  • Liquid Penetrant Testing : Solvent And Water Washable Method.
  • Magnetic Particle Testing(Wet Fluorescent Method) : Prod Type & Central Conductor Type.
  • Radiography Testing : lr 192 & Co 60.
  • Ultrasonic Testing
  • Man Power: Level II In All NDT.
  • NDT Procedure : RT, UT, MPT, LPT, and VT Procedures Approved By EN & ASNT Level III

Additional Approvals

    • Welders are qualified as per requirement of ASME section IX & BS EN ISO 15614-1
    • Impact test at -196°C
    • Heat Treatment Qualification